Alleima® 10RE51 is a duplex (austenitic-ferritic) stainless steel characterized by resistance to stress corrosion cracking (SCC), high resistance to pitting, crevice and general corrosion and very high mechanical strength.
Standards
- UNS: S32900
- EN Number: 1.4460
Product standards
EN 10297-2, EN 10294-2, ASTM A790
Chemical composition (nominal) %
C | Si | Mn | P | S | Cr | Ni | Mo |
---|---|---|---|---|---|---|---|
0.04 | 0.5 | 0.8 | ≤0.040 | ≤0.030 | 26 | 5 | 1.3 |
Mechanical properties
Proof strength | Tensile strength | Elong. | ||||
---|---|---|---|---|---|---|
Rp0.2a) | Rp1.0a) | Rm | Ab) | |||
MPa | ksi | MPa | ksi | MPa | ksi | % |
≥485c) | ≥70c) | ≥470d) | ≥68d) | 620-800 | 90-116 | ≥20 |
1 MPa = 1 N/mm2
a) Rp0.2 and Rp1.0 correspond to 0.2% offset and 1.0% offset yield strength, respectively.
b) Based on L0 = 5.65 √S0 where L0 is the original gauge length and S0 the original cross-section area.
c) Requirement according to ASTM A790
d) Requirement according to EN 10297-2
Disclaimer: Recommendations are for guidance only, and the suitability of a material for a specific application can be confirmed only when we know the actual service conditions. Continuous development may necessitate changes in technical data without notice. This datasheet is only valid for Alleima materials.